Terrible problem with using animation with digit photos

kelly · Post by **kelly** » Mon Oct 03, 2005 9:07 pm

Some of the digital pictures that I upload to my movie end up look terrible when I add animation such as zooming in. Some areas of the pictures start flashing, moving or get pixellated. It's especially noticeable if the picture has something a building or structure in it, or if water is in it. Is there a way to prevent this from happening? It also happens to pictures that I scan in.

jcmmarin · Post by **jcmmarin** » Tue Oct 04, 2005 6:17 am

Hi,
I have the same problem and I dont find a way to solve it.

erock1 · Post by **erock1** » Tue Oct 04, 2005 1:27 pm

VS just takes your digital still and magnifies the picture for the zoom effect in much the same way a digital camera uses its digital zoom, not optical. VS is just cropping your picturte and then enlarging the result to fill the frame which leads to a much lower quality picture.

Post by **Ken Berry** » Tue Oct 04, 2005 9:29 pm

...though you should only notice the lower quality if the original digital photo was of low quality to start off with...