Hartpaul I've never used the Change to Target tool. So I fired up PSPx8 and tried it. (Today is the first time I have used PSPx8 in a long time). I was surprised at how well it works. But if you need to have more control over opacity, reflections etc I would still rather open a new Raster Layer, or two, and do it the long hard way!!!!
bruce
adding stripes to an auto image
Moderator: Kathy_9
-
bruce1951
- Posts: 176
- Joined: Sun Dec 31, 2017 2:39 am
- System_Drive: C
- 32bit or 64bit: 64 Bit
- ram: 8gb
- Location: Australia
-
JoeB
- Posts: 2760
- Joined: Fri Mar 28, 2008 10:04 pm
- System_Drive: C
- 32bit or 64bit: 64 Bit
- motherboard: LENOVO 4524PE4 ThinkCentre M91p
- processor: 3.10 gigahertz Intel Quad Core i5-2400
- ram: 8 GB
- Hard_Drive_Capacity: 4.6 TB
- Corel programs: PSP 9, X7 to 2019, 32 & 64-bit
- Location: Canada
Re: adding stripes to an auto image
Appreciate the suggestion about using the Change to Target tool. I knew it was available but I guess habit had made me forget to make use of it.
Regards,
JoeB
Using PSP 2019 64bit
JoeB
Using PSP 2019 64bit
-
vintageseabee77
- Posts: 5
- Joined: Sat Mar 24, 2018 10:33 pm
- System_Drive: C
- 32bit or 64bit: 64 Bit
Re: adding stripes to an auto image
I need to thank all of you who've added your input to help me. I won't be doing much w/the info y'all have shared, since a cold germ has put this senior citizen
into a bad place for a while. Feeling a bit better but wanted to let y'all know it'll be a few days before I start practicing what you've shared. Thanks again for all your help.
into a bad place for a while. Feeling a bit better but wanted to let y'all know it'll be a few days before I start practicing what you've shared. Thanks again for all your help.