Render conpleted , but there's no video in my computer

[qq51099008]

source video
1080i(tv capped) format:ts 25 fps no audio

output optinos:
MPEG Transport-Stream Files
24 bits, 1920 x 1080, 25 fps
Frame-based
(HDMV-PAL), 16:9
H.264 Video
Video data rate: Variable (Max. 9900 kbps)
Audio data rate: 384 kbps
Dolby Digital Audio, 48 KHz, 2/0(L,R)

i tried many times , sometimes the render was comple without warning or error , sometimes the render process was failed by the message "File format mismatch" . but there`s no output video in my computer in either way

[BrianCee]

If the process completed without error then the video is almost certainly on your computer somewhere - when you go "Share >> Create video File >> ????" and then the Create video File 'save' dialogue box opens check at the very top of that dialogue window as to where exactly your finished videos are going - they can be any where on your computer according to what is specified in that window

[Ken Berry]

What have you specified as your working folder in VS? Look in Settings > Preferences > General up towards the top. Normally any generated video is stored in whatever folder you have specified there.

[qq51099008]

I've used vs for many years, and I'm sure the folder i set doesn't have the video. The process is not completed the way you think. It stuck somewhere, and moments later the rest completed in just a few seconds, which I think is where it goes wrong. It should't be that quick. Strangly the problem didn't show when I set the output video as DV(19:6).

-----------------------------------------------------------------
Thanks guys, I Konw where the problem is.

I split it into two parts and render separatly. I found the second part can't be renderd unless you set it to render as DV19:6 .......