how do I multi-trim

duckrogers · Post by **duckrogers** » Fri Jun 03, 2005 12:24 am

It seems when I make one trim (using beginning and end points) I cannot play other parts so I can do additional trims? How are you suppose to multi-trim if you can't play the non-trimmed parts (where you hope to do more trimming)?

Inversing doesn't help.

jcc · Post by **jcc** » Fri Jun 03, 2005 3:23 am

In Multi-Trim to play non-marked sections, hold down the SHIFT KEY and press SPACE or click the PLAY button. That information is not mentioned in the manual, but comes up as a HINT when you 'mouse-over' the PLAY button.

duckrogers · Post by **duckrogers** » Fri Jun 03, 2005 5:44 am

Thank you.