Zoom image quality

budbon · Post by **budbon** » Mon May 16, 2011 4:28 am

I am using both Paint Shop Pro X3 & Video Studio X3. I'm putting together a slideshow and when I use Pan & Zoom to zoom on a particulr subject (as a bee on a flower) after so much zoom the picture blurs. I have a very good camera and the photo remains sharp in Paint Shop Pro in extreme zoom. Is there a way to sharpen the image while zoomiing in Video Studio?

Post by **Ron P.** » Mon May 16, 2011 11:46 am

Have you tried using the Sharpen filter? It is located in the FX library. Just drag it onto your clip, then click the customize button. You can keyframe the strength at various times. So when you're zoomed in, it will sharpen your image.

budbon · Post by **budbon** » Mon May 16, 2011 7:05 pm

Thanks Ron. I spend a lot of time going thru the user guide trying to figure things out and then come here and get the answer in minutes. Again, thanks

Trevor Andrew · Post by **Trevor Andrew** » Tue May 17, 2011 9:34 am

Hi

There was an issue when using the Anti-Flickering filter

See Rons comments, first page -- last post

http://forum.corel.com/EN/viewtopic.php ... &hilit=map

alexleominster · Post by **alexleominster** » Tue May 17, 2011 11:30 am

never knew there was a sharpen filter..
nice find, glad i read this
ta
al

Alludo USER to USER Web Board

Zoom image quality

Zoom image quality

Re: Zoom image quality

Re: Zoom image quality

Re: Zoom image quality

Re: Zoom image quality