Creating an object from a selection leaves artifact line!

[Alemond1]

:evil:This is so frustrating! PIx3 is leaving an artifact of my selection after I convert it it an object...neccessitating my having to go back and manually clone-out the left-over border...and then "blur" the area in order to make it all seem somewhat natural. This didn't happen with the last version and I am hoping it is something in my settings. It owuld be so much easier if coverting a selection to an object did just that...and didn't require an extra 5-10min per object! Grrr!

Any ideas?

Thanks!

[Trev Bowden]

This fringe is caused by anti-aliasing There are two filters for dealing with it De fringe and remove matt neither are always successful I handle such by contracting the selection 1 or 2 pixels, Inverting and deleting.

[Alemond1]

Thank you! I'll try that!

-Al