insert graphics - cool 3d

warrenrenshaw · Post by **warrenrenshaw** » Fri May 13, 2005 12:51 am

When clicking the insert graphics command, I am taken to the path editor. The forground images asks for a emf or wmf. My images have been saved as such in corel but when chosen the message reads "the current data not supported..."

Will I be able to modify simple graphics to 3d?

Terry Stetler · Post by **Terry Stetler** » Tue May 17, 2005 5:43 pm

WMF's have to have closed paths. Are you saving them that way in Corel?

warrenrenshaw · Post by **warrenrenshaw** » Tue May 17, 2005 9:25 pm

No my images were not save closed paths. Further information would be helpful if you have any. Warren

Alludo USER to USER Web Board

insert graphics - cool 3d

insert graphics - cool 3d

closed paths wmf