Alludo USER to USER Web Board

For discussion of the Alludo products listed below ONLY
https://forum.corel.com/EN/

Video Studio 10 using EASYCAP USB, Audio Sync Problems

https://forum.corel.com/EN/viewtopic.php?t=34963

Page 1 of 1

Video Studio 10 using EASYCAP USB, Audio Sync Problems

Posted: Fri Mar 13, 2009 4:37 pm
by gaz2800
I am having issues with Audio slowly becoming more and more out of sync as I capture Analogue Video from my Video8 Camcorder using the EasyCap USB2 device, component RCA inputs. I have stopped all processes, disconnected all USB devices and increased the Ulead Video Studio prority. I set capture and leave to run until the end of a 90 minute tape. When I replay the Audi is a good few seconds ahead of the video. I am using stk1150 driver but am unable to find a later version.

Any advice much appreciated as, if I had any, I would have pulled all my hair out by now.

Posted: Fri Mar 13, 2009 5:08 pm
by Black Lab
Are you using the VS8 to capture? Did the EasyCap come with it's own capture software? If so, try using that.

Posted: Fri Mar 13, 2009 5:11 pm
by gaz2800
The EASYCap came with VIdeo Studio 10 SOftware. I am using my video 8 camcorder connected via Component RCA connections.
All times are UTC+01:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited