Page 1 of 1
Partial Render-Recover?
Posted: Sat Nov 22, 2008 8:23 pm
by Ken Veal
About 80% of a project rendered then the "had to close" box came up
in VS 11+.
Is there any way I can carry from where it finished.The partially rendered
file is is a Video_TS folder ...................Ken
Posted: Sat Nov 22, 2008 9:25 pm
by Black Lab
If it had to close there probably was a problem. Even if you could resume at that point I don't know if that would be advisable.
I take it that you haven't tried rendering again?
Posted: Sat Nov 22, 2008 9:46 pm
by Ken Berry
And program that I know which writes files to a DVD structure (i.e. the VOB, IFO and BUP files) always asks to wipe the existing files before it will start again...
Partial render
Posted: Sun Nov 23, 2008 12:33 pm
by Ken Veal
I had run out of PC time so I did not try rendering again but will do so,
have never had this problem before from VS 9 up.Will do a disc clean up
which I forgot to do, try again + report back thanks.
Partial Render
Posted: Sun Nov 23, 2008 7:56 pm
by Ken Veal
Deleted the partial file, did a disc clean up, rendered again OK then made 4 copies of disc OK ....................Ken