To get rid of Red line

Mike Warren · Post by **Mike Warren** » Wed Aug 29, 2007 7:49 pm

Beneath preview window on Studio 10 I selected mark in and mark out to mark beginning and end of a clip on timeline, so I can render clip only. However, after rendering, I cannot get rid of red line. There must be an easy way of doing this... but can't find it. THanks for help. Mike

Black Lab · Post by **Black Lab** » Wed Aug 29, 2007 8:01 pm

There are two ways. Go to the beginning of your project - mark in. Go to the end of your project - mark out.

Or, under the Preview Window are the Trim Handles (black, triangular). Drag them to the extreme left and right to restore your begin and end points.

Icelander · Post by **Icelander** » Thu Aug 30, 2007 5:12 pm

Thank you for this. That red line always drives me mental when I accidentally put it in the timeline.

Black Lab · Post by **Black Lab** » Thu Aug 30, 2007 5:30 pm

Yes, it's easy to do when you are setting a mark out point for a clip, but you are accidentally in project mode.