I wonder if someone could explain the message / question "Save Changes to blah blah blah" after burning a DVD from a project.
After I author and menu a project I always save it prior to going to the final tab for burning.
Its always made me wonder, why, if I do save the final version prior to burning the DVD, why does DVDWS always as this question before exiting back to Windows?
What difference would it make answering yes or no?
Saving Changes
-
sjj1805
- Posts: 14383
- Joined: Wed Jan 26, 2005 7:20 am
- System_Drive: C
- 32bit or 64bit: 32 Bit
- motherboard: Equium P200-178
- processor: Intel Pentium Dual-Core Processor T2080
- ram: 2 GB
- Video Card: Intel 945 Express
- sound_card: Intel GMA 950
- Hard_Drive_Capacity: 1160 GB
- Location: Birmingham UK
Only guessing here but what I think happens, not only in DVD workshop but also other programs - especially MediaStudio is that after rendering a video it then references the rendered copy rather than the raw copy.
I noticed when I created this tutorial
DVD Workshop transitions between menu pages that when you do the second render it was much much faster than the first. This I put down to the fact that it must have a smart render routine built in. With the particular project I refer to above, the only substantial change is the addition of the transitions between pages.
I noticed when I created this tutorial
DVD Workshop transitions between menu pages that when you do the second render it was much much faster than the first. This I put down to the fact that it must have a smart render routine built in. With the particular project I refer to above, the only substantial change is the addition of the transitions between pages.