Forum Error Message

Moderator: Ken Berry

Post Reply
Black Lab
Posts: 7429
Joined: Wed Dec 15, 2004 3:11 pm
operating_system: Windows 8
System_Drive: C
32bit or 64bit: 64 Bit
Location: Pottstown, Pennsylvania, USA

Forum Error Message

Post by Black Lab »

The last couple of days I have gotten the following error message when I try to respond to a post or send a pm. With a post it usually double posts it, with a pm it won't send it at all (that is why I couldn't pm a moderator about it). Am I the only one experiencing this?

Could not connect to smtp host : 110 : Connection timed out

DEBUG MODE

Line : 112
File : smtp.php
joosuna
Posts: 225
Joined: Sat Dec 11, 2004 8:32 pm
operating_system: Windows 7 Ultimate
System_Drive: F
32bit or 64bit: 64 Bit
processor: intel dual core 3 Ghz
ram: 12Gb
Video Card: nvidia
Hard_Drive_Capacity: 2000
Location: LosAngeles, California, USA
Contact:

Post by joosuna »

Black Lab..it might be just you...cause I have not experienced the problem. Perhaps others have ?
regards
Joe O
Black Lab
Posts: 7429
Joined: Wed Dec 15, 2004 3:11 pm
operating_system: Windows 8
System_Drive: C
32bit or 64bit: 64 Bit
Location: Pottstown, Pennsylvania, USA

Post by Black Lab »

My PM finally went thru to GeorgeW and he replied that others are, in fact, having similar problems and expects it to be fixed soon.
railroadguy

Re: Forum Error Message

Post by railroadguy »

Black Lab wrote: Could not connect to smtp host : 110 : Connection timed out
DEBUG MODE
Line : 112
File : smtp.php
This has been happening to me also the last three times I have posted, BUT, by opening a new browser window before trying to go back and repost, I went to the forum and saw that my post was there.

Some people get the error and start backing up and doing it again and again without first looking to see if indeed the post made it and we end up with 2 and 3 posts of the same thing. I suspect some people operate their software in much the same manor :twisted:
railroadguy

Post by railroadguy »

Yep, it just did this to me for the above post. Popped open a new browser went to the forum and my post was here.
User avatar
Ken Berry
Site Admin
Posts: 22481
Joined: Fri Dec 10, 2004 9:36 pm
operating_system: Windows 11
System_Drive: C
32bit or 64bit: 64 Bit
motherboard: Gigabyte B550M DS3H AC
processor: AMD Ryzen 9 5900X
ram: 32 GB DDR4
Video Card: AMD RX 6600 XT
Hard_Drive_Capacity: 1 TB SSD + 2 TB HDD
Monitor/Display Make & Model: Kogan 32" 4K 3840 x 2160
Corel programs: VS2022; PSP2023; DRAW2021; Painter 2022
Location: Levin, New Zealand

Post by Ken Berry »

Yes, does the same for me with the same message for the last couple of days.

However, I have seen this happen a couple of times before on the Board, so I knew I would only have to post once. Then I simply re-open the main Video Studio forum index page and see that my post is there.

Hope someone takes action soon to correct it, though. :twisted:
Ken Berry
Post Reply