Can't play whole project any more

Noob99 · Post by **Noob99** » Tue Dec 19, 2006 4:57 am

New question

I was putting together a project with lots of clips and got pretty far.
Now I have this red line in the timeline view and every time I try to play the project it starts at that point.

What is the red line and how do I get rid of it? It appeared at a place where I added a title to a video segment.

Now I can't play my project from the begining any longer

What did I do?

Noob99 · Post by **Noob99** » Tue Dec 19, 2006 5:14 am

Seems like as soon as I post a question I figure it out...
Although I don't know what the red line was, I just deleted that segment and did it again and now it is fine. Could it have been a partial mark-in mark-out?

Post by **Ron P.** » Tue Dec 19, 2006 5:29 am

That red line was in fact a Mark-In/Mark-Out indicator. To remove the red line, in Project Mode, drag the trim handles out to the far left and right. This is the same as setting up a Preview Range. If you want to see a segment of your project, in High Quality, setting up a Preview Range, and going to Share>Create Video File, setting the format, naming the file, and selecting the radial button for Preview Range, instead of Entire Video, that segment will be rendered.

Noob99 · Post by **Noob99** » Tue Dec 19, 2006 6:36 am

Thank you! I had done it again and then could not pass a particular point so I was very glad to see your reply and that fixed the problem!