Modifying default DVD template

brianosmi · Post by **brianosmi** » Sat Nov 11, 2006 1:09 am

I am trying to use one of the stock DVD templates that come with VS10+. I have four titles and would like all four to display on one page of the menu, thereby not needing a second menu page.

I cannot for the life of me figure out how to move the title from the second page to the same page as the other three titles. This seems like it would be a simple thing to do, and there is plenty of real estate on the menu, but I just cannot figure it out.

Is there a way for me to do this?

Thanks for any insight!

sjj1805 · Post by **sjj1805** » Sat Nov 11, 2006 1:30 am

Please view:
Authoring a DVD
VS9 & PI11: Creating a Custom DVD Menu Layout
Creating a DVD Menu from scratch

brianosmi · Post by **brianosmi** » Sat Nov 11, 2006 4:21 am

Thanks again for your assistance. Your link in my other post was a gold mine!

brianosmi · Post by **brianosmi** » Sat Nov 11, 2006 4:52 am

Steve, I read your post on SmartScene menus, and your comment about how there are really only two of them, one with three links and one with four.

I thought to myself, "Great, this solves my problem because I only need 4 links!"

So I dig into VS10+ and start looking at my SmartScene menus and discovered that I must only have one menu, because all of mine have 3 links... Back to square 1 with this...

If you have any suggestions as to where my second menu is, the one with the four links, I'm all ears. Right now I'm just bummed out...

sjj1805 · Post by **sjj1805** » Sat Nov 11, 2006 5:02 am

Please check your PM.

brianosmi · Post by **brianosmi** » Sat Nov 11, 2006 3:19 pm

Thanks!