Time Code Misbehaviour

Vincej · Post by **Vincej** » Fri Jun 16, 2006 5:38 am

everytime I open VS9 Capture panel I notice that the time code has not been reset to zero even though I might start a new project. It increments from where it left off from the prevous project so it might read 1.20.30 when I have just started.

What's going on ? I can't reset it can I. Ideas ?

Tks Vince

shredding · Post by **shredding** » Fri Jun 16, 2006 11:35 pm

are you capturing from the same tape?

sjj1805 · Post by **sjj1805** » Sat Jun 17, 2006 12:46 am

The timecode is taken from the camcorder tape, not the program.

Vincej · Post by **Vincej** » Sat Jun 17, 2006 3:37 am

yes I'm capturing from the begiining of the same tape - making multiple passes at a particular scene and each time it just increments rather than going back to 0 which is th start of the the tape.

thanks Vince

Vince