Poor Output Quality with Ulead COOL 3D

xGSTQ · Post by **xGSTQ** » Wed May 31, 2006 11:30 am

Well This is probably my end but im after a little advice

I first created an image in photoshop and then saved it as a .bmp (also tried as .jpg)

I then add the image to Ulead 3D as a background and add my text and effect.

What i do notice is as soon as i add the background the image instantly goes kind of fuzzy ...

This is then confirmed when i save the image for out put.

Here is the image leaving photoshop:

And here it is after editing in Ulead:
( you can see the fuzzyness around the logo and weapon)

I dont know what im doing wrong ? any sugestions are very welcome !!

pauley · Post by **pauley** » Fri Jun 02, 2006 4:18 pm

Not sure what your image parameters were, but it looks like either:
- your quality settings were not set high enough
- you made an image with a high dpi and brought into a lower resolution 3D project.

Can you rule those out?

Pauley

xGSTQ · Post by **xGSTQ** » Fri Jun 02, 2006 5:12 pm

Thanks for the responce.

in reply to your question, I presume the settings for these are in the tab under

Image > Display Quality
Image > Output Quality
Image > Object Quality

I have all 3 of them set to Best.

Image > Use Cache view, is checked and im not sure what that is to be honest.

No other settings are jumping out at me ?

Hope that helps m8

Ped

htchien · Post by **htchien** » Fri Jun 02, 2006 7:13 pm

Please check http://phpbb.ulead.com.tw/EN/viewtopic. ... 4290#54290

Best regards,
H.T.

xGSTQ · Post by **xGSTQ** » Fri Jun 02, 2006 7:23 pm

Ok Thanks !!

So this means i cant make an image 400x120 without the edges bluring,

as you stated in that post the image has to be 256x256, 512x512 and so on..

I hope this will be adressed in any future updates if any

thx very much for the help i recieved and very quick too !!

Ped