When I add an object or a text it's placed behind the object exinting.
I go to "Object" "Align", but it doesn't allow me to bring it forward or backward.
(The options in "Align" are not in white (grey), therefore can't be selected)
Any idea?
Object alignment
Moderator: Ken Berry
-
alfons
- Posts: 178
- Joined: Tue Jan 08, 2013 12:07 pm
- System_Drive: C
- 32bit or 64bit: 64 Bit
- processor: i7 9700
- ram: 32GB
- Video Card: Gforce GTX1650
- sound_card: Sound Blaster Audigy FX
- Hard_Drive_Capacity: 1TBSSD+4GB
- Monitor/Display Make & Model: HP 24Uh
- Corel programs: VS X4-X5-X8-X10-2018-2020-2022
- Location: Catalunya (Europe)
-
lata
- Site Admin
- Posts: 14185
- Joined: Thu Jan 19, 2012 6:21 am
- System_Drive: C
- 32bit or 64bit: 64 Bit
- motherboard: ASUSTeK COMPUTER INC A88XM-A USB 3 1 Rev X 0x
- processor: 4 10 gigahertz AMD A10-7890K Radeon R7
- ram: 16 gb
- Video Card: on board
- sound_card: Realtek High Definition Audio
- Hard_Drive_Capacity: 500 SSD
- Monitor/Display Make & Model: LG W2242 [Monitor]
- Corel programs: CVSX, 19, 20, 22 PSP2023, PI, MS3D
- Location: UK
Re: Object alignment
By align we have to select more than one object
Try pressing Ctrl + the screen object – then align should be active.
But easier -- you could set the Position "Z" will send the object back or forwards using – negative number –
center would be “0”
Try pressing Ctrl + the screen object – then align should be active.
But easier -- you could set the Position "Z" will send the object back or forwards using – negative number –
center would be “0”
Trevor