NEW! PaintShop Pro 2019

Undocumented Feature

Moderator: Kathy_9

Undocumented Feature

Postby Kingston » Sat Dec 01, 2018 2:08 am

There's an undocumented feature where you can create a node(s) on a motion arrow, and then move the node to a new position, as in this video on YouTube: https://youtu.be/tb9xPAues8c

This allows you to create a back-and-forth motion.

That's about as complicated as I get. But you can get even more complicated. For example, you can create more than one node on an arrow, but you have to create each new node between the tail and the node closest to the tail. And afterwards, moving any node other than the one closest to the tail is tricky stuff. I think I had to use the arrow keys while the right mouse button was held down. And then there were some things that required PhotoMirage to be in the Trash-Can mode.


You can easily crash or lock up PhotoMirage with these undocumented features.
MotionStudio 3D 1.0; Corel VideoStudio Ultimate X7 (w/o sp1) (Download), Corel PaintShop Pro 15.2.0.12 (Download)
Kingston
 
Posts: 423
Joined: Tue Jul 14, 2009 7:26 am
Location: CA, USA
operating_system: Windows 10
System_Drive: C
32bit or 64bit: 64 Bit
motherboard: Gateway [Acer] DX4860
processor: Intel Core i5 3rd gen. 3 GHz
ram: 8 GB
Video Card: Intel HD 2500
sound_card: Bluetooth
Hard_Drive_Capacity: 1 TB
Monitor/Display Make & Model: Dell ST2210; Samsung SmartTV 3D 40"

Return to PhotoMirage

Who is online

Users browsing this forum: No registered users and 2 guests