LeviFiction wrote:Patara, the paste problem with the image being offset is a known bug. But it's only experienced by some people not by all. Exactly why this is I don't know. I have never personally experienced this bug. Though if you use the Offset command you can "fix" it....I think. Again I've never had the bug so I don't know if that will fix it.
As for the color problem, I have never seen that at all. Not as a post here or in my own attempts. So with that sort of bug I'd see about getting technical support.
Corel did make some "improvements" to the way it interprets some colors but I find it hard to believe that they are the cause of this. Then again I know so little about it. And I can't get a trial of the Hallmark Card software to test this against.
I see this when I copy & paste something from the internet, but not from other programs on my computer.
I make a rectangular selection of the 'wrong' bit, promote it to layer and move the original to the left and the promoted selection the the right. Everything fits
I didn't know this was a X4 bug, I thought it was the way something had been coded.